TM 10-1670-327-23&P
0030 00
REPLACE continued
12. Reattach upper control line assembly to the new extended gore. Form a girth hitch on attachment
loop IAW WP 0017 00. Remove any twists or turns in the control line and thread the attachment loop
through the loose girth hitch in the end of the control line. Repeat this process for the remaining
control line assembly.
13. Fold the new attachment loop in half aligning the two marks. Place the new attachment loop over the
canopy so that the canopy is sandwiched between the new loop and the 1-inch mark. Ensure that the
mark aligns with the edge of the canopy forming a 1-inch loop (figure 2,3).
14. Sew the new loop into place using two bartacks, one horizontal and one vertical. The horizontal
bartack should runoff the end of the new loop.
15. Verify the attached line's continuity.
16. Using a bartack sewing machine on the extended gore, place bartacks in the same manner as
original (figure 2,3), at the junctions of the trailing edge of the new extended gore and the
reinforcements.
END OF WORK PACKAGE
0030 00-4
