• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 2-5.  Log Record Entries for Unit and Intermediate Repair and Inspection Data Page - TM-10-1670-271-23P_30
Figure 2-7.  Attaching Pack Tray to the T-10B Harness

TM-10-1670-271-23P Parachute Personnel Type: 35-Foot Diameter T-10B Troop Back Parachute Assembly NSN 1670-00-091-0720 Manual
Page Navigation
  12    13    14    15    16  17  18    19    20    21    22  
ARMY TM 10-1670-271-23&P AIR FORCE TO 14D1-2-464-2 MARINE CORPS TM 01136B-23&P/1 (5)  Note page.  A page is provided at the back of a parachute log record to accommodate recording of additional  data  pertinent  to  the  serviceability  of  a  parachute  canopy  assembly  (figure  2-6).    This  shall  also include the month and year the item was placed in service. Figure 2-6.  Data Entries for a Log Record Note Page. 2-5.  Receipt of Used Parachute.  Upon initial receipt of used parachute proceed as follows: a.  Follow procedures given in paragraph 2-4a, and check each component for excessive wear and tear. b    If  defects  or  damages  are  discovered,  process  the  parachute  for  maintenance  at  the  maintenance level assigned by the MAC (Appendix B). 2-6.  After-Use Receipt.    When  a  parachute  is  received  at  the  maintenance  activity  following  Its  use  by  the parachutist  during  air  delivery,  it  must  be  given  a  shakeout  and  aired  (para  2-11),  and  if  necessary,  cleaned (para 2-12) before it can be returned to service.  If a parachute is issued but is not used, it does not need to be given a shakeout, however, it must be given a routine inspection by a qualified parachute rigger. Section III.  ASSEMBLY Paragraph Page 2-7 Assembling the T-10B Parachute ................................................................... 2-7 2-8 Adapting the T-10B Parachute Harness to Open-Circuit Scuba Equipment ........................................................................................... 2-10 2-7.  Assembling the T-10B Parachute.  When the parachute is received from the supply activity and before it is packed for use, the components must be assembled.  This must be accomplished during the layout of the parachute (para 2-16c).  If, in assembling components, any component is found to be defective, the parachute must be processed for repair.  Place the components on a packing table and obtain proper layout of the canopy assembly, then assemble components as follows. a.  T-10B Harness.  Attach the harness to the pack tray as follows: (1)  Place the pack tray on table with back strap retainers and keepers up, and with end flap containing the static line slack retainer toward apex end of table. 2-7







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.