TM 10-1670-268-20&P 0004 00
0004 00-6
(3) ALIGN & INSTALL INBOARD ROLLER PADS (BOTH SIDES OF EACH PAD)
CAUTION
Do not hammer aligning tool into holes. Damage to the captive nuts
will occur.
CAUTION
Do not hammer bolts through holes of side rails.
NOTE
If for any reason it is not possible to install some of the roller pad
bolts, it is permissible to omit only one roller pad bolt per panel.
However, two missing roller pad bolts must not be adjacent to a
panel joint.
NOTE
Before installing side rail bolts, insure the suspension bracket
assembly, if required, is positioned at the proper side rail holes.
Refer to FM 4-20.102 (FM 10-500-2) for the item being rigged.
