TM 10-1670-268-20&P 0004 00
0004 00-18
(9)
Position a side rail (1) along each edge of the platform overlapping the outboard roller pad.
Use a punch to align the bolt-holes. Install 3/8-inch x 1¼-inch hex head bolts (2) with 3/8-
inch flat washers (3) through the side rail and the roller pad into the captive nuts (4). Start
the bolts two or three turns by hand.
(10) Repeat step (9) above with another side rail of equal length on the opposite side of the
platform.
NOTE
No bolts can be missing from the extreme forward and rear platform
panel edges.
(11) Using an impact wrench with a 9/16-inch socket, tighten all roller pad bolts (1) installed in
the two in board roller pads (as shown in the diagram below).
(12) Using an impact wrench with a 9/16-inch socket, tighten the roller pad bolts (2) and (3) to
within one-quarter inch of the top of the flat washer. This will ensure that the side rails are
securely attached. DO NOT fully tighten these bolts at this time. Refer to the illustration
below for bolt locations.
OUTBOARD ROLLER PAD
NUT RETAINER ASSEMBLY
(PORTION OF PANEL ASSEMBLY
NUT BAR USED TO CONTAIN THE
CAPTIVE NUTS)
4
1
3
2
2
3
1
SIDE RAIL
BOLT INSTALLATION
SEQUENCE
1ST – ALL INBOARD ROLLER
PAD BOLTS
2ND – BOLTS ON INSIDE OF
OUTBOARD ROLLER PAD
3RD – BOLTS ON OUTER SIDE
OF OUTBOARD ROLLER
PAD
3
1
2
ROLLER PAD INSTALLATION SEQUENCE
