TM 10-1670-268-20&P 0004 00
0004 00-20
CAUTION
Use of a pry-bar should not be necessary during the initial assembly
of the Dual Row platform. If using a pry bar to install the link on an
assembled platform, exercise extreme caution to avoid bowing or
bending the side rail.
(b) Each link slides into the groove between the platform rail and the platform panel end.
Use a pry-bar if necessary to open the groove as the link is inserted.
(c) Slide link forward until its bolt-holes are matched up with platform clevis bolt-holes 31
through 34.
(d) Install four ½-inch X 3 7/32-inch side rail bolts, and ½-inch flat washers, on each side of
the platform into clevis bolt-holes 31 through 34 and corresponding holes in the fitting.
Install the two remaining side rail bolts (35 and 36), washers and bushings. Tighten the
hex head bolts two or three turns by hand.
BOLT HOLES 31-34
