TM 10-1670-269-23&P
0028 00
0028 00-4
(5)
Continue tacking around the cone base using the procedure in step (4), above, until the
needle and thread length are passed to the panel inside at hole no. 2. Remove all slack
from the completed tacking.
(6)
Pass the needle and thread length up through the parachute pack panel at a point adjacent
to the outside edge of the cone base and hole no.1.
(7)
Pass the needle and thread length over the outside edge of the cone base, and down
through hole no. 1 to the inside of the parachute pack panel.
(8)
Pass the needle and thread length back up through the parachute pack panel at a point
adjacent to the outside of the cone base and hole no. 2.
(9)
Pass the needle and thread length over the outside edge of the cone base and down
through hole no. 2 to the inside of the parachute pack panel.
