ARMY TM 10-1670-275-23&P
AIR FORCE TO 13C5-25-2
NAVY NAVAIR 13-1-26
2-32. Riser Clevis.
This task covers:
a.
Repair
b.
Replace
Tools:
Equipment Condition.
Knife, Item 4, Appendix B
Inspected (paragraph 2-9)
Cleaned (paragraph 2-11)
Materials/Parts:
Laid out on work table
Cord, Nylon, Type I, Item 10, Appendix D
Reference'
Wire, Item 41, Appendix D
Group No. 0112, MAC, Section II,
Personnel Required:
Appendix B
43E(10) Parachute Rigger
Group No. 0112, MAC, Section II, Appendix B
a. Repair. Repair a riser clevis using the following procedures.
(1) Replacing a clevis pin retaining cord
(a) Cut and remove original clevis pin retaining cord from riser clevis body, clevis pin and safety
pin (figure 2-71)
(b) Cut a 16-inch length of type I nylon cord and sear ends.
(c) Pass one half of cord length around riser clevis body, join ends and make a square knot snug
against clevis body (figure 2-71).
(d) Pass one tie running end through the eye of clevis pin. Make an overhand knot In running
end.
(e) Secure tie end against clevis pin eye with a square knot, leaving a 3/8 inch running end.
(f) Secure opposite cord running end to the eye of safety pin using procedures in (d) and (e)
above.
2-97
