TM 10-1670-280-23&P 0012 00
0012 00-12
e. Insert the ¼-inch screw with serrated lock washer through the hole on the bottom of the bracket, into
the threaded hole in the bottom end of the cutter and tighten the screw finger tight.
NOTE
A four-line check for proper layout shall be performed before applying
tension.
f.
Rigger check number 1.
5. Applying tension. Attach the nylon webbing strap routed through the connector links to a tension device
and apply tension.
NOTE
A tension jack, chain hoist, power winch, or a vehicle may be used as a
tension device when applying tension to the parachute.
6. Threading the reefing line cutter at line 61.
NOTE
The G-11C uses two 10-foot type IV reefing lines. The reefing lines will
be fabricated IAW the instructions in WP 0060 00, ILLUSTRATED LIST
OF MANUFACTURED ITEMS, of this manual.
