TM 10-1670-280-23&P 0012 00
0012 00-17
j.
Route the running end of the webbing on the left side of the reefing line cutter through the end loop of
the reefing line of the left gore group.
k. Route the running end of the webbing on the right side of the reefing line cutter through the end loop
of the reefing line of the right gore group.
l.
Secure the ends of the securing tie together over the reefing line cutter with a square knot. Route
one running end of the tie up through the side screw slot of the cutter bracket.
m. Secure the running ends together with a square knot and a locking knot with an overhand knot in
each running end.
n. Trim ends to two-inches.
CAUTION
When installing the center line, ensure that it is not entangled or
wrapped around the suspension lines or suspension risers.
8. Completing center line installation.
a. Disconnect the bridle loop from the stationary post and dress the upper lateral band making sure the
vent lines are centered and separated.