TM 10-1670-286-20
EXTRACTION LINE PANEL 0008 00
STOWING 120-FOOT SIX LOOP EXTRACTION LINE TO EXTRACTION LINE PANEL
0008 00-1
THIS SECTION COVERS:
Stowing
INITIAL SETUP
Tools
Knife – NSN 5110-00-162-2205
Materials/Parts
(2)
Extraction Line Panel – NSN 1670-01-183-2678
Extraction Line, 120 FT Six Loop – NSN 1670-01-062-6312
Cloth, Muslin-Cotton – Item 4, Appendix C
Paper, Kraft – Item 9, Appendix C
Webbing, Cotton, Type I, ¼-Inch Wide – Item 16, Appendix C
Webbing, Nylon, Tubular, ½-Inch Wide – Item 17, Appendix C
Personnel Required
92R (10) Parachute Rigger
Equipment Condition
All equipment shall be serviceable and ready for use.
References
WP 0002 00-2
Extraction Line Panel
WP 0003 00 Service and Repair
TM 10-1670-296-20&P
Extraction Line
STOWING.
NOTE
Throughout this task the terms Right, Left, Upper, Lower,
Clockwise, Counterclockwise, Top and Bottom indicate the
directions, as viewed by the Rigger, standing at the Tension
Board end of a parachute pack table looking toward the apex
end.
When “two Extraction Line Panels” are laced together, the item
then takes on the noun nomenclature of Extraction Line Bag.
Load attaching end of the Extraction Line Bag is laced closed
with ½-inch tubular nylon webbing.
1. Layout.
a. Position two Extraction Line Panels on pack table or suitable surface with stow loops facing up and
lengthwise (figure 1).
