TM 10-1670-287-23&P
0030 00
0030 00-2
a. Cut crimped edge of damaged grommet at three or four points.
b. Remove grommet and washer.
c. Lock replacement grommet and grommet washers in place with die set.
2. Replace unserviceable slider as follows:
a. Cut and remove tacking from risers.
b. Using a 7/16-inch open-end wrench, loosen barrel nuts on connector links and remove
risers.
c. Remove connector links and control lines from risers.
d. Remove slider from suspension lines and control lines.
NOTE
Ensure 28-inch side of slider faces to front or leading edge of canopy.
Connector Link
Barrel Nut
Riser
Tacking
