TM 10-1670-287-23&P
0037 00
0037 00-8
(1)
Repair. If loose or broken threads are present, restitch with size E nylon thread in
accordance with WP 0015 00.
(2)
Replacement. Replace damaged hook and pile tapes as follows:
NOTE
Damaged hook and pile tapes must be replaced in complete
lengths.
(a) Remove damaged tape by carefully removing stitching securing it to container.
(b) Locate replacement tape directly over location where previously removed.
(c) Sew in place with light-duty sewing machine, size E nylon thread and 7 to 11
stitches per inch using original stitch pattern.
h. Hook and Pile Tape on Ripcord Protector Flap. Replace hook and pile tape on ripcord
protector flap as follows:
NOTE
Stitching will be visible on the flap after the hook and pile
tape is replaced on the pack stiffener.
(1)
Remove unserviceable hook and pile tape as required.
(2)
Replace hook and pile tape as required and sew using a medium-duty sewing
machine, size E nylon thread and 7 to 11 stitches per inch.
i.
Hook and Pile Tape on the Pack Stiffener. Replace hook and pile tape on the pack
stiffener as follows:
(1)
Remove unserviceable hook and pile tape as required.
(2)
Replace hook and pile tape as required and sew using a medium-duty sewing
machine, size E nylon thread, and 7 to 11 stitches per inch.
j.
AR2 Power Cable Sleeve. Replace AR2 Power Cable Sleeve as follows:
(1)
Cut a 20-inch length of Tape, Nylon, Type III, OD, ¾-inch wide binding tape.
(2)
Cut and sear an 18 ½-inch x 3-inch piece of green, textured nylon duck cloth.
3-IN
18 ½-IN
