TM 10-1670-287-23&P
0038 00
0038 00-2
2. Insert barrel of replacement grommet through accommodating hole in material and ensure
grommet flange is located on same side of material as original grommet.
3. Position the grommet on the die with barrel facing up and place washer over grommet barrel.
Ensure grommet barrel and washer are aligned to prevent off-center setting of grommet.
4. Using a punch and rawhide mallet or other non-steel impact device, spread grommet barrel
by hammering until barrel collar is rolled down smooth on washer. If grommet barrel splits
during hammering, remove and replace installed grommet with a serviceable item from stock.
Repeat the procedure in steps 2. and 3., above.
END OF WORK PACKAGE
