TM 10-1670-293-23&P
0028 00
f.
Install a socket assembly in the center of the folded end, and a stud assembly in the center of the
reinforcement duck, as shown. Use the following installation procedures:
(1)
Cut the fabric for the socket and stud assemblies; use a mallet and lead cutter block, and
an appropriate sized double- or single-bow cutter.
(2)
Installation of a snap fastener may be performed by three different methods. The most
common method is the hand-held method that requires the use of a leather mallet, or other
non-steel impact device; a holder to hold the appropriate sized chuck; and an anvil, which is
used to contain a compatible sized die.
0028 00-5
Change 1
