TM 10-1670-296-20&P                                                    0005 00 0005 00-10 Table 1.  Preventive Maintenance Checks and Services – continued B – Before D – During A – After INTERVAL ITEM NO. B D A ITEM TO BE CHECKED   OR SERVICED EQUIPMENT NOT READY/ AVAILABLE IF: 10 Lanyard Arming Wire.   Inspect lanyard (1) for loose or broken stitching, cuts, worn or frayed webbing, and presence of foreign matter.  Inspect reworked arming wire lanyards by insuring the safety tie (type I ¼-inch cotton webbing) is properly routed and secured.   Reworked arming wire lanyards can be identified by four small identification marks located around the circumference of the copper crimping sleeve, in addition, both ends should be flared.   Refer to WP 0020 00. Verify length of lanyard.  If necessary, fabricate a 25-foot lanyard for the M-2 Release IAW WP 0021 00. Lanyard (1) has loose or broken stitching, cuts, or worn or frayed webbing, or foreign material is present.  Safety tie is misrouted, improperly tied or secured with of the wrong material.  Four small identification marks are not present or flared ends.