TM 10-1670-327-23&P
0016 00
3. Pull up on the pull up cord (figure 47, item 1) until the closing loop is exposed and insert temporary
pin. The extractor cap (figure 47, item 2) should be centered over the extractor at this point.
1
2
Figure 47. Inserting Temporary Pin.
4. Place the upper pull up cord (figure 48, item 1) through the upper left grommet on the left flap (rigger
view) (figure 48, item 2), then through the upper right grommet on the right flap (figure 48, item 3).
Apply even tension utilizing the T-bar (figure 48, item 4) until the closing loop is exposed and insert
temporary pin (figure 48, item 5).
4
5
1
2
3
Figure 48. Exposing Closing Loops and Inserting Temporary Pin.
5. Rigger check number 7.
0016 00-34
