TM 9-1370-201-12
(3) Assure that safety pin is in place and that
(5) Using forefinger of right hand and thumb
ejection dial indicator is set on SAFE.
of left hand, set ejection dial indicator (fig. 2-3) by
turning clockwise to desired setting (table 2-1). A
(4) Visually inspect flare for damage.
spring-loaded detent holds the ejector dial indicator at
Contact authorized disposal personnel for disposal of
each setting and aids in setting fuze in darkness, since
damaged flares.
engagement of the detent can easily be felt.
(6) Remove loading gate of dispenser
WARNING
assembly by releasing latch and lifting gate off support
For launch from aircraft operating
pins.
below 70 knots indicated airspeed
(7) Load flare (fig.
(KIAS), a minimum fuze setting of
assembly by putting pull cable assembly in overhead
1,000 feet shall be used.
track and pushing flare along base tray until it is against
dispensing gate.
Figure 2-9. Loading flare on dispenser assembly.
2-10
