TM 9-1370-202-12
CAUTION
between ignition fuze setting dial and lanyard disconnect
Do not permit tape to overlap
weather cap.
(j) Slide cardboard disk down lanyard until it
(m) Hold lanyard in place while securing it
rests on ignition fuze setting dial. Position disconnect in
with 2-inch tape (A and B, fig. 3-11). Assure that tape
fuze cavity on top of cardboard disk (A, fig. 3-10).
does not cover swivel loop. (This step requires two
(k) Carefully
remove
flare
from
arming
people.).
trough.
(n) Secure weather cap and swivel loop with
(l) Replace weather cap (B, fig. 3-10). Wind
tape (C, fig. 3-11). Fold over approximately one-half
lanyard around flare approximately 1'/2 inches down
inch of tape on free end to form pull tab. Take care to
from top of fuze (C, fig. 3-10). Lanyard will encircle
place pull tab on lanyard side of swivel loop.
flare case approximately 11/2 times.
Figure 3-9. Placement of disk.
3-11
