TM 10-1670-280-23&P 0012 00
0012 00-13
a. Cut two 18-inch lengths of ½-inch tubular nylon webbing to be used as reefing line securing ties.
b. Rotate the reefing line cutter at line 61 upward and pass one end of a securing tie from left to right
through the reefing line cutter hole.
c. Center the tie with an equal amount of webbing on each side of the reefing line cutter.
d. Pass the running end of the webbing on the left side of the cutter through the end loop of one of the
10-foot reefing lines.
e. Pass the running end of the webbing on the right side of the cutter through the second reefing line
end loop.
f.
Secure the ends of the reefing line securing tie together over the reefing line cutter with a square
knot.
g. Route one running end of the tie up through the side screw slot of the reefing line cutter bracket.
h. Secure the running ends together with a square knot and locking knot with an overhand knot in each
running end.
i.
Trim ends to two-inches.