• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Serving the canopy vent
Installing M-21 reefing line cutter.   cont.

TM-10-1670-280-23P Parachute Cargo Type: 100-Foot Diameter Model G-11B G-11C and G-11D NSN 1670-01-016-7841 Manual
Page Navigation
  138    139    140    141    142  143  144    145    146    147    148  
TM 10-1670-280-23&P                                                       0013 00 0013 00-11 j. Trim tie ends to 2-inches. k.    Ensure the parachute inspection data pocket (log record pocket) on the inside of the bridle loop remains accessible. l. Attach the bridle loop to the stationary post. 4.    Installing M-21 reefing line cutter.  Install an M-21 reefing line cutter at lines 1, 31, 61 and 91 as follows: a.    Remove ¼-inch screw and insert the cutter into the upper end of the cutter bracket.  Ensure the cutter arming cable is pointed toward the canopy vent. b.    Align the screw that protrudes from the side of the cutter with the slot in the upper end of the cutter bracket. c.    Slide the cutter into the cutter bracket until the cutter lower end is flush against the inside bottom end of the bracket. d.    Turn the cutter one-quarter turn to allow the screw, which protrudes from the cutter side, to fit into the indentation located in the center of the bracket.    NOTE Do not use any type of tool to tighten the reefing line cutter bottom screw.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.