TM 10-1670-286-20
EXTRACTION LINE PANEL 0005 00
STOWING 60-FOOT ONE LOOP EXTRACTION LINE TO EXTRACTION LINE PANEL
0005 00-1
THIS SECTION COVERS:
Stowing
INITIAL SETUP
Tools
Extraction Line Panel – NSN 1670-01-183-2678
Extraction Line, 60 Foot, One Loop – NSN 1670-01-064-4452
Band, Rubber, Retainer – Item 1, Appendix C
Cloth, Muslin-Cotton, Type III – Item 4, Appendix C
Paper, Kraft – Item 9, Appendix C
Webbing, Cotton, Type I – Item 16, Appendix C
Webbing, Tubular, ½-Inch Wide – Item 17, Appendix C
Personnel Required
92R (10) Parachute Rigger
Equipment Condition
All equipment shall be serviceable and ready for use.
References
WP 0002 00-2
Extraction Line Panel
WP 0003 00
Service and Repair
TM 10-1670-296-20&P
Extraction Line
STOWING
NOTE
Throughout this task the terms Right, Left, Upper, Lower, Clockwise,
counterclockwise, Top and Bottom indicate the direction, as viewed by the
Rigger, standing at the Tension Board end of a parachute pack table looking
toward the apex end.
When “two Extraction Line Panels” are laced together, the item then takes
the noun nomenclature of Extraction Line Bag.
Either end of the Extraction Line for the 60-Foot One Loop may be the load-
attaching end.
1. Layout.
a. Position Extraction Line Panel on pack table or suitable surface with stow loops facing up and running
lengthwise (figure 1).
