TM 10-1670-286-20
EXTRACTION LINE PANEL 0004 00
MARKING AND RESTENCILING EXTRACTION LINE PANEL
0004 00-1/(2 Blank)
THIS SECTION COVERS:
Marking, Restenciling.
INITIAL SETUP
Materials
Personnel Required
Brush, Stenciling-Item 3, Appendix C
92R (10) Parachute Rigger
Ink, Marking-Item 7, Appendix C
Marker, Felt Tip, Black-Item 8, Appendix C
Equipment Condition
Pen, Ballpoint-Item 10, Appendix C
Stencil Board Oiled-Item 12, Appendix C
Layout on packing table or other suitable area.
MARKING
NOTE
Stenciling should be used whenever possible. A ballpoint pen or felt tip
marker should be used only where stenciling is not possible, or when
stenciling devices are not available. Any type ballpoint pen using black or
blue ink may be used for marking on labels only.
Original stenciling data or marking that becomes faded, illegible,
obliterated, or are removed as a result of performing a repair procedure will
be remarked with a ballpoint pen, felt tip marker, or restenciled. All
marking or restenciling will be done on or as near as possible to the
original location and should conform to the original lettering type and size.
Using marking devices such as ballpoint pen or felt tip marker, mark on or as near as possible to original location
and conform to original lettering type and size.
RESTENCILING.
1. Cut oiled stencil board to original lettering type and size of data to be restenciled.
2. Place cut stencil board over or near as possible to original marking to be restenciled.
3. Place additional sheet of stencil board beneath the area to be stenciled to prevent the marking ink from
penetrating to other areas.
4. Hold stencil board in place and using stenciling brush filled with parachute marking ink restencil original
marking.
END OF WORK PACKAGE
