TM 10-1670-287-23&P
0047 00
0047 00-6
b. Using a 5/32-inch drill bit, drill two holes to accommodate placement of the clamp as shown.
c. Place backing plate on the backside of the junction plate and install clamp using two screws and
two nuts. Hand-tighten at this time.
3. Install AR2 Power Cable Assembly, Main follows:
a. Starting at the left wing flap, route the power cable housing through the 1 ¾-inch hole located
above the AR2 pocket.
AR2 Main Power Cable
Assembly
Left Wing Flap
11/16 -IN.
5/32-IN.
1-IN.
