TM 10-1670-287-23&P 0005 00
0005 00-7
d. Secure the risers to a suitable anchor point.
e. Starting from the risers (rigger view), check to ensure the right and left risers are attached to the
correct side.
f.
Check each riser to ensure the 3-ring assembly is facing down.
g. Trace each riser up to the connector link and ensure each barrel nut faces inboard and closes
upward toward the canopy.
h. Check the slider to ensure the reinforcement webbing is facing the canopy and the arrow is facing
down.
NOTE
During the process of tracing each control line/cascade line, half
twists are acceptable.
i.
Check each control line to ensure it is not misrouted by following the base line of the control line
from the canopy-attaching loop down to the toggle.
Risers
Slider
Suspension
Device
Clamps
