TM 10-1670-293-23&P
0027 00
NOTE
The slide must be retracted slightly to permit the legs of the lever to
straddle slide forward of the slide ears.
d. Position the assembled actuator and lever assembly on the female fitting and align the assembly
pinholes with the female fitting assembly holes.
e. Insert the assembly pin through one leg of the actuator and lever pinholes. The assembly pin is
inserted so the pinhead is in the down position when the assembly is mounted on the holding tool.
f.
Position the safety clip (cover) engaging hinge between the shoulder on the underside of the
female fitting. Push the assembly pin through the hinge and the opposite leg holes. All parts are
now engaged and pivoting on the assembly.
g. Replace die No.1 with die No. 2; re-engage the female fitting onto the holder.
h. Insert the washer on the assembly.
i.
Using punch 2A, flare pin end by applying light taps with a hammer.
j.
Using punch 2B, roll the end of the pin by applying light taps with a hammer.
Change 1
0027 00-14
