TM 10-1670-293-23&P
0004 00
T-10C/T-10D TROOP BACK PARACHUTE ASSEMBLY
ASSEMBLING THE T-10C/T-10D TROOP BACK PARACHUTE
THIS TASK COVERS:
Assembly
INITIAL SETUP:
Materials/Parts
Tape, Pressure Sensitive (Item 34, WP 0053 00)
Personnel Required
92R (10) Parachute Rigger
Equipment Condition
Parachute canopy in proper layout on packing
table or other suitable surface.
ASSEMBLY
Assembling the T-10C/T-10D Parachute. When the parachute is received from the supply activity,
and before it is packed for use, the components must be assembled. This must be accomplished
during the layout of the parachute (WP 0011 00).
If, in assembling components, any component is found to be defective, the parachute must be
processed for repair. Place the components on a packing table and obtain proper layout of the
canopy assembly; then assemble components as follows:
1. T-10C/T-10D Harness. Attach the harness to the pack tray as follows:
a. Place the pack tray on the table, with back strap retainers and keepers up, and with the end
flap containing the static line slack retainer toward the apex end of the table.
b. Attach the harness to the pack tray, as illustrated in figure below, by threading each of the
pack tray diagonal back-strap-keepers through the harness diagonal back-strap-channels (for
the required size), and through the back-strap retainers.
0004 00-1
Change 1
