TM 10-1670-296-20&P 0012 00
0012 00-4
3. Splicing Type XXVI Nylon Webbing. Splice a cargo sling or extraction line as follows:
NOTE
Splicing may be performed on the webbing loops of all lines and slings,
except the 3-foot sling, to repair damage areas. Three splices per loop
are permitted on lines less than 20-feet in length. Four splices per loop
are permitted on lines 20 to 60-feet in length. Five splices per loop are
permitted on lines longer than 60-feet. The total number of splices
permitted per loop includes the original loop connector splice.
NOTE
Splicing shall not be performed when a damaged areas is less than 24-
inches from another splice. A splice may extend to a point no closer
than 12-inches from a webbing loop end. The original webbing loop
connector splice may be cut if it is damaged or directly adjacent to a
damaged area. Splices will be centered between fixed keepers.
a.
If an inside loop within 12-inches of the loop end is being spliced, cut the tacking which secures the
buffer at each end and remove the buffers temporarily. Adjust the inside loop so the splice will not
be within 12-inches of the webbing loop end. Insure the splice will not be centered under the keeper
loops.
Keeper
Typical Webbing
Sling Section
Outside Tape Starts Here
Tape, Pressure Sensitive, Fil.,
Reinforcement, Type II or III
(PPP-T-97)
Inside Tape Starts Here
Webbing Ply
Section A-A Not To Scale
