TM 10-1670-299-20&P
TO 14D1-2-470-2
NAVAIR 13-1-41
(14) Keeper pin strap. Replace a damaged keeper pin strap (1) with a 13-inch length of 1-inch Type IV nylon
webbing as follows:
(a) Remove damaged keeper pin strap (1) from cable and conduit assembly (2), and remove keeper pin (3)
from keeper pin strap (1).
(b) Sear ends of replacement webbing.
(c) Pass one end of webbing through keeper pin, fold end under 2 inches and sew using Size E thread, 7 to
11 stitches per inch and a type LD sewing chine.
(d) Pass other end of webbing through cable and conduit assembly, fold end under 2 inches, and sew
according to details shown. Use same machine, thread and stitch range as in (c) above.
(f) Replacing Harness Hardware.
(1) Keeper pin (3). Replace a bent, sprung, burred or nicked keeper pin with a serviceable like item from
stock. Open damaged pin, and remove it from keeper pin strap. Thread strap loop into place between forks of new pin.
2-127
