TM 10-1670-327-23&P
0016 00
Stow The Suspension Lines
1. Remove the connector links from the tension device.
2. Make the remaining 2 riser stows by S-folding the risers (figure 20, item 1) into the pack tray (figure
20, item 2) from upper to lower, outside to inside ensuring the connector links (figure 20, item 3) are
in the center of the pack tray.
NOTE
2-inch retainer bands (commonly known as large) will be used for stows attached to the
pack tray. 1-1/4-inch (commonly known as small) retainer bands will be used for the 2-
inch "free" stows. All retainer band stows are single turn only.
3
2
1
Figure 20. Making Two Remaining Riser Stows.
3. Rotate the container 90 clockwise.
4. Make the first stow (figure 21, item 1) to the upper right of the pack tray. Ensure the stow (figure 21,
item 1) extends to the edge of the pack tray (figure 21, item 2).
0016 00-17
