TM 10-1670-327-23&P
UNIT MAINTENANCE
MC-6 PERSONNEL PARACHUTE SYSTEM
NSN 1670-01-527-7537
MARKING AND RESTENCILLING
REPAIR
INITIAL SETUP:
Tools
Personnel Required
Brush, Stenciling (Item 8, WP 0097 00)
92R (10) Parachute Rigger
Materials/Parts
Equipment Condition
Ink, Marking (Item 31, WP 0109 00)
Lay out on packing table or other suitable area
Marker, Felt Tip, Permanent (Item 33, WP 0109
Pen, Ball Point (Item 34, WP 0109 00)
Stencil Board, Oiled (Item 40, WP 0109 00)
REPAIR
NOTE
Stenciling should be used whenever possible. A ballpoint pen or permanent felt tip
marker should be used only were stenciling is not possible, or when stenciling devices
are not available. Any type ballpoint pen using black or blue ink may be used for marking
on labels only.
Original stenciled data or marking that becomes faded, illegible, obliterated, or removed
as a result of performing a repair procedure, will be remarked with a ballpoint pen,
permanent felt tip marker, or restenciled. All marking or restencilling will be done on, or
as near as possible to, the original location and should conform to the original lettering
type and size.
MARKING
Using marking devices, such as a ballpoint pen or permanent felt tip marker, mark on, or as near as
possible to, the original location and conform to the original lettering type and size.
RESTENCILING
Proceed as follows:
1. Cut oiled stencil board to match the original lettering type and size of data to be restenciled.
2. Place cut stencil board over, or as near as possible to, the original marking to be restenciled.
3. Place an additional sheet of stencil board beneath the area to be restenciled to prevent the marking
ink from penetrating to other areas.
4. Hold the stencil board in place and, using the stenciling brush filled with parachute marking ink,
restencil the original marking.
0019 00-1
