TM 10-1670-280-23&P 0030 00
100-FOOT DIAMETER CARGO PARACHUTE
THIS TASK COVERS:
File, Flat (Item 6, WP 0050 00)
Mallet, Rawhide (Item 12, WP 0050 00)
Screwdriver, Flat Tip (Item 17, WP 0050 00)
Separator, Connector Link (Item 18, WP 0050 00)
Cloth, Abrasive (Item 2, WP 0059 00)
92R (10) Parachute Rigger
Unpacked, laid flat on repair table.
WP 0006 00
Inspect connector link assemblies in accordance with Table 1, PMCS, WP 0006 00.
Repair connector link assembly as follows:
1. Cleaning. Remove burrs, rough spots, rust or corrosion from a parachute connector link assembly by
either filing with a metal file or buffing with a crocus cloth.
2. Replacing a locking screw. Replace a damaged or missing locking screw on a parachute connector link
with a serviceable item from stock.
A parachute connector link assembly that is damaged beyond repair will be replaced with a serviceable L-bar
parachute connector link assembly from stock. Use the following procedures:
1. Using suitably sized flat-tip (slotted-head) screwdriver, remove the locking screws from the ends of
replacement L-bar parachute connector link assembly and disassemble the link (refer to the illustrations
2. Using suitably sized flap-tip (slotted-head) screwdriver, remove the two locking screws from the damaged
original parachute connector link assembly.