TM 10-1670-268-20&P 0014 00
UNIT MAINTENANCE
TYPE V PLATFORM
REAR PANEL ASSEMBLY
0014 00-1
THIS WORK PACKAGE COVERS:
Remove
Clean
Inspect
Install
INITIAL SETUP:
Tools:
Brush, Wire (Item 2, WP 0020 00)
File, Mill (Item 7/8, WP 0020 00)
Punch, Aligning (Item 15, WP 0020 00)
Socket, 3/4–IN. (Item 17, WP 0020 00)
Socket, 5/8–IN. (Item 18, WP 0020 00)
Socket, 9/16–IN. (Item 19, WP 0020 00)
Wrench, Box and Open, ¾-IN. (Item 23, WP 0020 00)
Wrench, Box and Open, 5/8–IN. (Item 27, WP 0020 00)
Wrench, Box and Open, 9/16–IN. (Item 28, WP 0020 00)
Wrench, Impact, ½-IN. Drive (Item 30, WP 0020 00)
Materials/Parts:
Brush, Scrub (Item 1, WP 0036 00)
Dishwashing Compound (Item 3, WP 0036 00)
Rag, Wiping (Item 5, WP 0036 00)
Replacement parts from stock, as required.
Applicable Configurations:
Type V only.
Personnel Required:
Two – Three 92R (10) Parachute
Rigger
General Safety Instructions:
Observe all Warnings and
Cautions.
REMOVE
Remove rear panel assembly as follows:
NOTE
Removing all main panels is recommended. It is very difficult to
remove the rear panel without removing all panels.
1. Position the platform upside down and remove side rails and rollers pads IAW WP 0012 00 and 0013
00.
2. Remove rear panel assembly (1) by slightly raising the panel to make disengaging easier.
Main Panel
Assembly
1
Tongue and Groove Interlock
