TM 10-1670-277-23&P 0011 00
0011 00-30
d. At end of static line that attaches to anchor line cable (the end with double looped release line), pass
the top loop of the static line up through the 1-inch connector link on the 6-inch connector strap.
e. Run the end loop of the release line through the loop in the static line from left to right or right to left,
rigger’s view, depending on the positioning of the load inside the aircraft.
f.
Using a tacking needle, run a length of single ticket 8/7-cotton thread through the running end (double
looped end) of sewn portion of the release line. Pass one end of the single ticket 8/7, cotton thread
through the 1-inch connector link and tie the loop with a surgeon’s knot and locking knot ensuring
there is no slack. Trim ends to within 2-inches.
NOTE
Remove the slack in the release line to the end opposite the one that is
tied with 8/7 cotton thread.
Top Loop
6-IN.
Connector Link
G-14 Clevis
8/7 Cotton
Thread
1-IN. Connector Link
