EXTRACTION LINE PANEL PROCEDURES FOR C-17 GLOBEMASTER III 0015 00STOWING 160-FOOT ONE LOOP EXTRACTION LINE TO EXTRACTION LINE PANEL WITH EXTRACTION BRIDLE ATTACHED 0015 00-5 c. Cut three 24-inch lengths of type I, ¼-inch cotton webbing. Girth hitch one length to stow loop 1, 6, and 12 on the right side of the bottom panel. Make an overhand knot three inches from the bottom of the stow loop (figure 4). Figure 4. Installing 24-inch Ties at Stow Loops 1, 6 and 12 d. Cut four 6 x 16-inch lengths of cotton muslin cloth and four 36-inch lengths of type I, ¼-inch cotton webbing and position at upper end of the panel. e. Place a 160-foot one-loop extraction line at upper end of pack table. f. Measure and mark a point on the extraction line 3-feet from one end (parachute attaching point). g. Route marked end of extraction line from the upper end to the lower end along right outer edge of bottom panel row of stow loops, align the 3-foot mark with lower right edge of panel. 3. Stow Extraction Line. a. Separate extraction line plies and wrap each ply with a piece of 6 x 16-inch cotton muslin cloth. b. Secure wrapped plies together at each end with two turns single type I, ¼-inch cotton webbing. Secure with a surgeon’s knot and locking knot. 24-inch Ties Top Panel Bottom Panel
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
