TM 10-1670-327-23&P
0006 00
5.
Close snap fastener (figure 3, item 4) and secure (figure 3, item 5).
2
1
2
5
5
4
Figure 3. Route Small Tuck Tab, Close Snap Fastener, and Snap Fastener Secured.
6. Repeat for the opposite side.
ASSEMBLE LOCKING KEY AND SOFT LOOP
1. Locate the canopy release assembly (figure 4, item 1) at the shoulder of the harness assemblies
(figure 4, item 2). Open the canopy release assembly cover plate (figure 4, item 3) by pulling
downwards.
2. Locate and remove the operating lug (figure 4, item 4) by depressing the two operating lug release
levers (figure 4, item 5).
3. Pass the soft loop (figure 4, item 6) through the grommet (figure 4, item 7) in the harness main lift
web insuring the webbing tab of the loop is positioned on the underside of the three ring riser release
(figure 4, item 8).
NOTE
Use lacing tape to assist routing the soft loop if needed.
4. Pass the loop (figure 4, item 6) through the slot in the operating lug (figure 4, item 4) and secure
using a girth-hitch knot (figure 4, item 9).
5. Repeat for opposite side.
0006 00-3
