TM 10-1670-327-23&P
0006 00
Attach Risers To Harness Assembly
1. Ensure risers and harness are free of tangles and twists and lay out harness with smooth side up.
Make certain risers are identified with a blue confluence wrap on each riser (figure 9, item 1).
2. Route large ring of upper main lift web (figure 9, item 2) through large riser ring (figure 9, item 3).
3. Rotate the large ring of the upper main lift web (figure 9, item 4) up 180 and insert small ring (figure
9, item 5) through large ring of upper main lift web (figure 9, item 4).
3
2
1
4
5
Figure 9. Laying Out Risers and Harness, Risers and Harness, and Assembling Risers and Harness.
4. Pass the locking loop lug (figure 10, item 1) and soft loop (figure 10, item 2) through the small ring
(figure 10, item 3) and insert the lug (figure 10, item 4) into the jaws of the canopy release assembly
5.
Insure that the lug is fully seated into canopy release assembly (figure 10, item 5).
6. Close canopy release cover (figure 10, item 7), locking the loop in place (figure 10, item 8).
7. The top of the lug should not be visible after closing the cover (figure 10, item 9) if properly seated.
CAUTION
A lug, which is not fully seated, will not allow the cover to close. Do not force the cover
closed.
0006 00-8
