TM 10-1670-201-23
T.O. 13C-1-41
NAVAIR 13-1-17
(1) When removing the damaged section, cut
(15) On the canopy outside, stitch completely
around the prepared area using the stitching criteria in
the section material diagonally across the corner with
the warp or filling. Allow the corner material of the
(13) above.
original section to remain intact and also allow a
(16) Reposition the item(s) removed or laid
sufficient amount of material to remain to preclude the
aside in (2) above in the original location (s) and
replacement section overlapping the pocket band.
reattach each item to the canopy by restitching
(2) Except for the procedure in (1) above,
according to original construction details and paragraph
complete the section replacement using the applicable
3-9. Stitching will be made using the stitching specifics
criteria outlined in paragraph a above and the details in
cited in the applicable item equipment publication.
(17) Stencil informational data or other
NOTE
markings on the replacement section using the
When replacing a gore section on a
procedures in paragraph 3-5.
biasconstructed canopy using the
b. Modified Section Replacement. If a gore section
modified replacement method, it is
which is located next to the lower lateral band on a bias-
not necessary to remove the V-tab or
constructed canopy does not have damage extending
pocket band from the radial seam
into a corner that is bounded by the lower lateral band
located alongside the damaged
and a radial seam, the section may be replaced using a
modified method as follows:
section.
NOTE
When replacing a gore section on a
lower lateral band that has a net
attached to it, removal of the new is
not necessary.
Change 3 3-32
