TM 10-1670-265-12&P
T.O. 13C7-1-12
4-8. Installation instructions.
a. Tools required.
Rigger's knife, NSN 5110-00-162-2205
b. Assembly of ASPSU.
(1) Insure safety tag and pin assembly is
securely attached to the arming cable assembly.
(2) Remove and discard the shorting connector
from the cutter module.
(3) Join the two modules together by alining
modules using the beveled end of each and the retainer
holes as guides. Pressing the units together mates the
electrical interface connector.
(4) Lock the two modules together by screwing
down the four captive screws until tight.
NOTE
Installation of retainer line will not be performed until ASPSU is rigged on the HAARS.
4-2
