TM 10-1670-268-20&P 0005 00
TYPE V AND DUAL ROW AIRDROP PLATFORM
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS), INTRODUCTION
0005 00-1/(2 Blank)
GENERAL
The following describe PMCS procedures on the unit support levels. The PMCS table has been provided
to ensure both the type V and dual row platforms are in proper operating condition, and ready for its
primary mission.
SCOPE
The following work packages (WP 0008 through WP 0016 00) contain maintenance procedures that are
the responsibility of the specified technician, as authorized by the Maintenance Allocation Chart (MAC),
and the Source, Maintenance, and Recoverability (SMR) coded items that are identified in the Repair
Parts and Special Tools List (RPSTL).
MAINTENANCE FUNCTIONS/PROCEDURES
Each of the mentioned work packages above identifies a maintenance function specified in the MAC. All
maintenance procedures required to complete a maintenance function are identified under “This Task
Covers:” in the order in which the work is most logically accomplished.
LUBRICATION INTERVAL
Not applicable.
CORROSION PREVENTION AND CONTROL (CPC)
Corrosion Prevention and Control (CPC) of Army materiel is a continuing concern. It is important that any
corrosion problems with this item be reported so that the problem can be corrected and improvements
can be made to prevent the problem in future items.
While corrosion is typically associated with rusting of metals, it can also include deterioration of other
materials, such as rubber and plastic. Unusual cracking, softening, swelling, or breaking of these
materials may be a corrosion problem.
If a corrosion problem is identified, it can be reported using Standard Form SF 368, Product Quality
Deficiency Report. Use of keywords such as "corrosion,” "rust," "deterioration," or "cracking" will ensure
that the information is identified as a CPC problem. The form should be submitted to the address
specified in DA PAM 738-750, Functional Users Manual for the Army Maintenance Management System
(TAMMS).
END OF WORK PACKAGE
