TM 10-1670-268-20&P 0011 00
UNIT MAINTENANCE
TYPE V AND DUAL ROW AIRDROP PLATFORM
TANDEM LINK / SUSPENSION BRACKET ASSEMBLY
0011 00-1
THIS WORK PACKAGE COVERS:
Disassemble
Clean
Inspect
Assemble
INITIAL SETUP:
Applicable Configurations:
All
Tools:
Brush, Wire (Item 2, WP 0020 00)
Cord, Extension (Item 3, WP 0020 00)
File, Mill (Item 7/8, WP 0020 00)
Punch, Aligning (Item 15, WP 0020 00)
Socket, ¾IN. (Item 17, WP 0020 00)
Socket, 9/16IN. (Item 19, WP 0020 00)
Wrench, Box and Open, ¾IN. (Item 23, WP 0020 00)
Wrench, Box and Open, 11/16IN. (Item 25, WP 0020 00)
Wrench, Box and Open, 5/8IN. (Item 27, WP 0020 00)
Wrench, Box and Open, 9/16IN. (Item 28, WP 0020 00)
Wrench, Impact, ½IN. (Item 30, WP 0020 00)
Materials/Parts:
Brush, Scrub (Item 1, WP 0036 00)
Dishwashing Compound (Item 3, WP
0036 00)
Rag, Wiping (Item 5, WP 0036 00)
Replacement parts from stock, as required.
Personnel Required:
Two Three 92R (10) Parachute Rigger
General Safety Instructions:
Observe all Warnings and Cautions.
DISASSEMBLE
1. Remove tandem link and/or suspension bracket assembly (1) from the platform as follows:
a. Using a ¾-inch wrench or socket, remove 3-hex head bolts and 3-flat washers from the side rail
to remove the tandem link/suspension bracket assembly (1).
b. Using a ¾-inch wrench or socket, loosen at a minimum, five additional side rail bolts to assist in
the removal of the tandem link/suspension bracket.
c. Using a 9/16-inch wrench or socket, loosen four of the outer edge roller pad bolts, two to three
turns immediately below the tandem link/suspension bracket.
2. Using a 5/8-inch and 11/16-inch wrench, disassemble tandem link and/or suspension bracket assembly
(1) by removing the 4 self-locking nuts (2), 8 flat washers (3), 4 hex head bolts (4), and bushings (5).
FRONT OF PLATFORM
REAR OF PLATFORM
1
5
3
4
2
3
