TM 10-1670-286-20
EXTRACTION LINE PANEL PROCEDURES FOR C-17 GLOBEMASTER III 0016 00
STOWING THE 140-FOOT THREE LOOP EXTRACTION LINE TO THE EXTRACTION
LINE PANEL WITH EXTRACTION BRIDLE ATTACHED
0016 00-5
Figure 5. Extraction Line Secured to Bottom Panel.
d. Beginning at the upper left corner of bottom panel, make first S-fold/stow of extraction line and
secure with previously installed type I, ¼-inch cotton webbing (figure 6).
Figure 6. First S-Fold of Extraction Line.
NOTE
Stows must not extend beyond the edge of the panel.
e. Working from left to right, stow and secure extraction line on bottom panel (13 stows on the left
and 13 on the right) with extraction line routed from bottom panel at lower left corner. Secure
extraction line using type I, ¼-inch cotton webbing with a surgeon’s knot and locking knot.
f. Run the extraction line up the left side of bottom panel. Wrap with second piece of cotton muslin
cloth and secure in three places with two turns single, type I, ¼-inch cotton webbing, (same as the
3-Foot Mark
Securing Ties
24 IN Tie on
1, 6, and 12
3 x 16 IN Cotton
Muslin Cloth
Bottom Panel
First S-Fold
