TM 10-1670-286-20
EXTRACTION LINE PANEL PROCEDURES FOR C-17 GLOBEMASTER III 0016 00
STOWING THE 140-FOOT THREE LOOP EXTRACTION LINE TO THE EXTRACTION
LINE PANEL WITH EXTRACTION BRIDLE ATTACHED
0016 00-2
STOWING
NOTE
Throughout this task the terms Right, Left, Upper, Lower, Clockwise,
Counterclockwise, Top and Bottom indicate directions, as viewed by the Rigger,
standing at the Tension Board end of a parachute pack table looking toward the apex
end. When two Extraction Line Panels are laced together, the item then takes the
noun nomenclature of Extraction Line Bag.
1. Attach Extraction Bridle to the Extraction Line Panels.
a. Place one Extraction Line Panel on packing table or suitable surface with the stow loops facing up
and running lengthwise (figure 1). Place second panel on top of first panel with the stow loops facing
down.
Figure 1. Extraction Line Panel with Stow
Loops Facing Up.
b. Using nine connector links, attach six to the double end webs of extraction bridle to bridle
attachment loops located on upper end of each panel. Attach three connector links to parachute
attaching webs of extraction bridle (figure 2).
Stow Loops
