TM 10-1670-327-23&P
0015 00
9. Flatten the deployment bag using the forearm (figure 49, item 4).
10. Extend suspension lines (figure 49, item 1) to the upper right corner (figure 49, item 2) of the of the
deployment bag. Form the first regular stow (figure 49, item 3).
11. Make the first regular stow in the upper right stow loop (figure 49, item 5).
4
1
1
2
5
3
1
Figure 49. Making the First Regular Stow.
NOTE
Ensure stow hook is around all the suspension lines when making stows. Regular stows
should extend through stow loops to the outer edge of the reinforcement panels, but not
more than 1 inch beyond the outer edge of the stow loop.
12. Remove packing paddle.
13. Rigger Check number 4.
14. Rotate deployment bag one-quarter turn clockwise (figure 50, item 1).
15. Grasp a section of the suspension lines (figure 50, item 2) approximately the width of the
deployment bag and, while sliding the bag on the table; form second regular stow in the upper left
corner of the bag (figure 50, item 3).
16. Using a stow hook, make second regular stow in upper left corner (figure 50, item 4).
0015 00-33